Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for ACTi CAM-6510
Summary of Contents for ACTi CAM-6510
-
Page 1: Quick Installation Guide
IP Indoor High Speed Dome CAM-6510 Ver. 090318 Quick Installation Guide... -
Page 2: Getting Started
Getting Started PACKAGE CONTENTS CAM-6510 Warranty Card Software CD Power & A/V Cable LAN/WAN Cable Power Adaptor 5.4” Transparent Cover Decoration Ring / Fixing Plate... -
Page 3: Physical Description
1.2 PHYSICAL DESCRIPTION Indoor High Speed Dome Bottom 1. Reset Button Step 1: Switch off IP device by disconnecting the power cable Step 2: Press and continue to hold the Reset Button. Reconnect the power cable while continuing to hold the reset button. Step 3: Keep holding the reset button depressed around 6 seconds, release the reset button. - Page 4 DVR, no two speed domes should be given the same ID or communication conflict may occur. When controlled only through Ethernet and software (without the use of an ACTi hardware decoder), the dome ID setting may be neglected. NOTE: The number “0”...
- Page 5 decimal single digit 5. 16 Pin Connector for LAN/WAN The LAN/WAN cable (shown as the figure below) is shipped with IP high speed dome. Please find it in the accessory bag. 6. 22 Pin Connector A 50cm data cable (shown as the figure below) is shipped with IP high speed dome.
- Page 6 The alarm pins are serviceable for connecting alarm input and output devices, such as alarm sensors, sirens or flashing light with the surveillance system. The table shown as follows lists the definition of alarm pins on the 22-pin connector.
-
Page 8: Mounting The Ip High Speed Dome
1.3 Mounting the IP High Speed Dome Generally, there are three kinds of ceiling mounting methods: surface mount, in-ceiling mount, and mounting with straight tube. The surface mounting kit is shipped with IP high speed dome. For more detailed information, please refer to Appendix A. Surface ceiling mount (cables exposed) 1.4 Basic Connections... -
Page 9: Quick Tour
Quick Tour This section guides you with a quick tour on IP high speed dome. 2.1 Configure the IP High Speed Dome 2.1.1 Make sure network environment Default IP of IP high speed dome is 192.168.0.100. Please make sure IP high speed dome and your PC are on the same network segment before running the installation. - Page 10 2.1.2 Open Internet Explorer with IP address NOTE: If your web browser is earlier than IE6, then download IE6 is recommended. NOTE: The IP high speed dome default IP address is set to 192.168.0.100 2.1.3 Login with default administrator’s account & password NOTE: Default administrator account is set to Admin, password is set to 123456, and click...
- Page 11 2.1.4 Preview the video NOTE: In your Client PC, please make sure the setting of Network Connections Type is set to Auto Negotation, since IP high speed dome follows MII standard. Otherwise, you might not see the live image.
- Page 12 2.15 Set the new IP address *Host Name : Enter in the domain name, Default Host Name is ACTi. *Language : Language setting for Web Configurator after Save Reboot. Default setting is English. *IP Address : The IP address of the LAN interface. The default IP address is 192.168.0.100.
- Page 13 2.1.6 Check Default Video Setting The streaming type [Version 1.0] – without audio function The streaming type [Version 2.0] – with audio function NOTE: Please make sure the TV Input (NTSC / PAL) is meet your requirement, and click button. 2.1.7 Click Save Reboot to restore all settings and please wait about 30 seconds for system reboot.
Need help?
Do you have a question about the CAM-6510 and is the answer not in the manual?
Questions and answers