Machine Specifications; Blade Guard - daltile 828 BrS Operating Manual

MACHINE SPECIFICATIONS

Blade Guard

Water Pump
Cutting Table
Detachable Legs
This sawing machine is designed and intended
for the professional contractor. The machine is
equipped with a saw head which moves hori-
zontally along a guiding beam. The material to
be cut is positioned on the saw table. The saw
must be fed through the material. Through con-
tinuous supply of cooling water the cutting qua-
lity is improved as well as the wear on the saw
blade is minimized. The cooling water also
absorbs the saw dust. The quality and construc-
tion of this sawing machine meet the highest
standards. The design is based on longevity
and minimal maintenance.
The stainless steel construction contributes to a
stable, rigid and durable sawing machine. The
4 detachable legs are to be installed in the leg
sockets at the underside of the water container
and fastened with the knobs.
Cutting Head
The cutting head is constructed of welded steel
components.
Blade Guard
Saw Spindle
The Blade Guard is a welded steel plate cap,
simple to remove and install for changing the
saw blade by unscrewing 2 knobs.
Saw spindle
The spindle flange is mounted on the saw spind-
le. The saw flange is to be mounted on the saw
spindle with a hexagon nut to clamp the saw
blade.
Cutting table
The cutting table is constructed of welded stain-
less steel components, equipped with anti-slip
rubber and adjustable side stop.
Cooling system
The electrical water pump is switched on simul-
taneously with the saw motor and supplies coo-
ling water to both sides of the saw blade. A
drain hole, with a plug, is located in the water
container. Mud flaps prevent most of the water
mist and make sure most water flows back in
the water container.
Technical Data:
Type ..............................................daltile 828 BrS
Capacity. ....................................................1,3 HP
Blade diameter/Arbor ..........................8" / 5/8"
Cutting height ..................................max. 1 3/8"
Saw spindle speed ............................3.360 RPM
Cutting length..................................................28"
Cutting table dim. ................................24" x 14"
Length ..............................................................44"
Width..........................................................15 3/4"
Height (without legs)................................15 3/4"
Weight ........................................................90 lbs
Noise level ............................................80 dB (A)
Noise level during sawing ..................90 dB (A)
DALTILE 828 BrS OPERATING MANUAL V02/2004R1 PAGE 11