Basic Use Of Your Dvd Player; Introduction; Front Panel Controls; Playing A Disc - Arcam DV88 Handbook

Basic use of your DVD player

Introduction

'Basic operation' explains how to play a DVD, CD or other type
of disc, including the use of the CR-314 remote control.
More sophisticated features – such as special playback modes
and programming jumps and playback sequences – are
described in the 'Advanced features' section.

Front panel controls

Switching on
Switch the unit on by pressing the
LED glows green when the unit is powered up and red when in
standby mode (standby is operated from the remote control).
Note that the remote control sensor is located on the right hand
side of the display window. Do not obstruct this or the remote
will not work.
HDCD indicator
This LED is located on the left of the display and lights green to
indicate when HDCD (High Definition Compatible Digital) material
is playing from suitably recorded audio CDs.

Playing a disc

Loading a disc
Press
place the disc on the tray, with the playback side facing down.
Some discs are double sided, in which case the side labelled
'side A' should face up, to access side A.
Press
after a pause of a few seconds.
Playing a disc
Most DVDs begin playing automatically, but some titles begin by
displaying a menu. Select the menu item 'Play movie' (or similar)
using the cursor pad, then press
For discs that do not play automatically (including CDs and
VCDs), press
Note that when playing DVDs, the drive mechanism operates
at much higher speeds compared to CDs and so may produce
more noise when loading and playing initial chapters.
POWER
on the front panel (or
LOAD OPEN
on the front panel to close the tray. The disc loads
LOAD
to start playback.
OK
.
PLAY
LOAD PLAY STOP
Fast play
Press
forward or backwards. For DVDs, VCDs and CDs the following
speeds for fast playback are available: x2, x4, x8, x20, x60 and
x100. Press the button repeatedly to cycle through the different
speeds. To resume normal playback speed, press
Fast playback is not available for MP3 discs.
Skipping chapters/tracks
To skip chapters (or tracks on a CD), press
When skipping back, the first button press takes you to the
button. The status
beginning of the current chapter. Pressing the button again
takes you to the start of the previous chapter.
Note that it is common for Video CDs to have only one track.
Pausing playback
Press
pause playback. To resume playback, press
panel or
Stopping playback
Press the
control to stop playback.
When playing a DVD, pressing
stop'. If you now press
it was stopped.
on the handset) and
If you press
resumes from the beginning of the disc.
Front panel menu navigation
Should you need to navigate a disc or title menu from the front
panel, use
'left' and
TRACK
PAUSE
or on the front panel or remote control to play fast
on the front panel or on the remote control to
PAUSE
on the handset.
button on the front panel or
STOP
once performs a 'resume
STOP
, playback resumes from the point
PLAY
twice, this is a 'complete stop', and playback
STOP
for 'up', for 'down' ,
PAUSE STOP
for 'OK'.
PLAY
DV88 DVD PLAYER
PLUS
POWER
.
PLAY
or .
on the front
PLAY
on the remote
for 'right', for
DV88
PLUS
9