Table of Contents
Advertisement
Basic use of your DVD player
Motion Adaptive Progressive Scan
INTRODUCTION
'Basic operation' explains how to play a DVD, CD or other type of disc,
including the use of the CR-314 remote control.
More sophisticated features – such as special playback modes and
programming jumps and playback sequences – are described in the
'Advanced features' section.
FRONT PANEL CONTROLS
SWITCHING ON
Switch the unit on by pressing the
green when the unit is powered up and red when in standby mode
(standby is operated from the remote control).
Note that the remote control sensor is located behind the FMJ badge
on the front panel. Do not obstruct this or the remote will not work.
HDCD INDICATOR
This LED is located below the FMJ badge and lights green to indicate
when HDCD (High Definition Compatible Digital) material is playing
from suitably recorded audio CDs.
PLAYING A DISC
LOADING A DISC
Press
on the front panel (or
LOAD
disc on the tray, with the playback side facing down. Some discs are
double sided, in which case the side labelled 'side A' should face up, to
access side A.
Press
on the front panel to close the tray.The disc loads after a
LOAD
pause of a few seconds.
PLAYING A DISC
Most DVDs begin playing automatically, but some titles begin by
displaying a menu. Select the menu item 'Play movie' (or similar) using
the cursor pad, then press
to start playback.
OK
For discs that do not play automatically (including CDs and VCDs),
press
.
PLAY
Note that when playing DVDs, the drive mechanism operates at much
higher speeds compared with CDs and so may produce more noise
when loading and playing initial chapters.This is normal.
button.The status LED glows
POWER
on the handset) and place the
OPEN
LOAD
PLAY
STOP
PAUSE
FAST PLAY
Press
or
on the front panel or remote control to play fast
forward or backwards. For DVDs,VCDs and CDs the following speeds
for fast playback are available: x2, x4, x8, x20, x60 and x100. Press the
button repeatedly to cycle through the different speeds. To resume
normal playback speed, press
Fast playback is not available for MP3 discs.
SKIPPING CHAPTERS/TRACKS
To skip chapters (or tracks on a CD), press
When skipping back, the first button press takes you to the beginning
of the current chapter. Pressing the button again takes you to the start
of the previous chapter.
Note that it is common for Video CDs to have only one track.
PAUSING PLAYBACK
Press
on the front panel or
PAUSE
playback. To resume playback, press
the handset.
STOPPING PLAYBACK
Press the
button on the front panel or
STOP
to stop playback.
When playing a DVD, pressing
you now press
, playback resumes from the point it was stopped.
PLAY
If you press
twice, this is a 'complete stop', and playback resumes
STOP
from the beginning of the disc.
FRONT PANEL MENU NAVIGATION
Should you need to navigate a disc or title menu from the front panel,
use
for 'up',
for 'down' ,
PAUSE
STOP
'OK'.
11
DV27 DVD PLAYER
POWER
.
PLAY
or .
on the remote control to pause
on the front panel or
PLAY
on the remote control
once performs a 'resume stop'. If
STOP
for 'right',
for 'left' and
on
for
PLAY
Advertisement
Table of Contents
