Using The Remote Control - Arcam DV88 Handbook

Using the remote control

Ensure that DVD mode is selected using the
toggle button. The 'DVD' LED above the
Dims or turns the DV88 's display on or off. Turning the display
PLUS
off generally gives a slight improvement in sound quality.
Pressing DISP once turns the display off; twice dims the display.
To restore the display to full brightness, press
This button enables you to repeat a selected
section from the disc (see page 12).
Press RPT to cycle through the repeat play options.
Fast play and Skip chapter/tracks
Play fast ( ) and Skip (
Pause ( ), Play ( ) and Stop ( ) (see page 9).
These buttons are described on the facing page.
DV88
PLUS
10
CD/DVD
CD/DVD
CD/DVD
is lit briefly when DVD mode is selected.
DISP (display)
a third time.
DISP
A–B
RPT (repeat)
) chapters/tracks in both
directions (see page 9).
OPEN
Opens and closes the disc tray.
Playback control
Advanced controls
0–9 keypad
This allows direct access to individual tracks on audio CDs. To
button
select a track, press the corresponding keypad button followed
by
OK
For example, to play track 15, press
CD/DVD REMOTE
CD DVD
CD
1 2 3
DVD
4 5 6
DISP
7 8 9
A-B
0
RPT CLEAR PROG
OK
OPEN
MUTE
P
SUBT TITLE MENU
MODE
ZOOM AUDIO MEM RTN
ANGLE SETUP STATUS SRCH
CR-314
. For tracks greater than 9, enter the digits in sequence.
, then
1
Standby
Press to toggle the standby state of the DVD player.
Standby
Note that Arcam CD players are not controlled by this button.
CLEAR
Use CLEAR within the 'Program' and 'Bookmark' menus to clear
a numeric field (see pages 12–13).
PROG (program)
You can program a selection of up to 20 chapters/tracks
from a disc to play in any order. Press
'Programme' menu (see pages 13 and 15).
Slow play
Press or on the remote control to play slow forward or
backwards. There are four speeds of slow playback: 1/5,
1/4, 1/3 and 1/2. Press the button repeatedly to cycle
through the different speeds. To resume normal playback
speed, press .
PLAY
Note that slow play does not apply to audio CDs.
Cursor pad and OK button
Use the cursor pad to navigate the On Screen Display (OSD) and
menu pages. Confirm your selection with the
MUTE
Stops sound to the speaker outputs of certain Arcam amplifiers.
Volume +/–
Adjusts the volume on Arcam remote-controllable amplifiers.
Note that the volume (+/–) controls and
no effect on the audio output level of the DVD players.
NOTE: Remember to install the two AAA batteries supplied
before trying to use your remote control.
Do not place anything in front of the display area on the
DVD player (where the IR receiver is located), or the
remote control may not work.
, then .
5 OK
PROG to access the
button.
OK
button have
MUTE