EasyPrinter S3 Programmers Manual
Command description
Based on Firmwareversion "EP000226".
Printer short state
Returns the status of the printer (bit coded info)
Command:
[SUB]
Returns:
[c] ... bit coded status info (1 byte)
Bit 0 ... Card sensor printposition
Bit 1 ... Card sensor front
Bit 2 ... Card sensor back = Card sensor printposition
Bit 3 ... Card in printposition
Bit 4 ... Printing in progress
Bit 5 ... Card has been printed
Bit 6 ... n.u.
Bit 7 ... ERROR
Start printing
After this command is received the printer starts to print the received data on
the card. If no card is inserted, the printer deletes the received data.
Command:
[FF]
Firmwareversion
Retrieve the actual firmwareversion of the device.
Command:
[ESC] a
Returns:
[pp][mm][nn][rr][LF]
[pp] ... 2 ASCII-characters coding the product type
[mm] ... 2 ASCII-characters coding major version of the firmwareversion
[nn] ... 2 ASCII-characters coding minor version of the firmwareversion
[rr] ... 2 ASCII-characters coding revision number of the firmwareversion
[LF] ... ASCII-characters "line feed" encloses the firmwareversion
Page 4 of 23
Version 1.3 - 19. April 2012