EasyPrinter S3 Programmers Manual
Start Loader
Starts the flash loader to update the programm file. For detailed information on
firmwareloading, please refer to "ANA-U Firmwareloader Manual".
Command:
[ESC] ><1
Set erase area
Sets the areas where the printer erases the information on the card (CXone
compatible).
Command:
[ESC] $a [n] [xx] [yyy] [XX] [YY]
[n] ..... Activation of the erase area in ASCII char ('1' = active > erase part of
the card ; '0' = inactive > erase the whole card)
[xx] .... x start position of the rectangle (upper left corner)
[yyy] ... y start position of the rectangle (upper left corner)
[XX] .... x end position of the rectangle (lower right corner)
[YYY] ... y end position of the rectangle (lower right corner)
Read printers error code
Reads actual error code of the printer.
Command:
[ESC] $E
Returns:
5 bytes where the first 4 bytes are the error code in ASCII hex format. Note:
All error above 0x8000 are fatal errors. Error code lower 0x8000 are warnings.
Error code 0x0000 means that there is no error.
Error codes:
0000 ... No error!
0001 ... Printer has to be cleaned!
0002 ... Printers flash parameters lost, printer switched to standard values!
8001 ... RAM defective!
8002 ... Printheads zero-position could not be found!
Read magnetic card JIS II
Reads the data from a magnetic stripe card. (The data must be encoded in JIS
II Standard)
Command:
[ESC] $Mr3
Page 10 of 23
Version 1.3 - 19. April 2012