EasyPrinter S3 Programmers Manual
Get permanent erase area mode
Command:
[ESC] L3000000000000
Returns:
13 ASCII characters:
[n] ...... Activation of the permanent erase area in ASCII char ('1' = active >
erase part of the card ; '0' = inactive > erase the whole card)
[xx] ..... x start position of the rectangle (upper left corner)
[yyyy] ... y start position of the rectangle (upper left corner)
[XX] ..... x end position of the rectangle (lower right corner)
[YYYY] ... y end position of the rectangle (lower right corner)
Set permanent erase area mode
Command:
[ESC] L2[xx][yyyy][XX][YYYY]
[xx] ..... x start position of the rectangle (upper left corner)
[yyyy] ... y start position of the rectangle (upper left corner)
[XX] ..... x end position of the rectangle (lower right corner)
[YYYY] ... y end position of the rectangle (lower right corner)
Paperticket mode
The card is printed without erasing. Once set for a card, mode can only be
cleared by rest commands. Mode is cleared after card printed!
Command:
[ESC] P
Command for graphic data
Send graphical data to the printer.
Command:
[ESC] Q [xx] {Data}
[xx] ... count of following data-bytes.
{Data} ........ xx data-bytes (binary 1 for printed dot)
Command for microlinefeed
Increments the actual graphicline by xx counts for command [ESC]Q to the
appropriate line in RAM.
Command:
[ESC] J [xx]
[xx] ... count of microlinefeeds. (Valuerange: 00 - 255 )
Page 9 of 23
Version 1.3 - 19. April 2012