EasyPrinter S3 Programmers Manual
Get printhead type
Command:
[ESC] %OD
Returns:
Always returns '3' for 300 dpi printhead.
Set printers IP address
Command:
[ESC] %OI [cccc]
[cccc] ... 4 Byte defining the IP address of the printer.
Set printers subnetmask
Command:
[ESC] %ON [cccc]
[cccc] ... 4 Byte defining the subnetmask of the printer.
Transparentmode ON
To start the transparentmode send the following data to the printer:
Command:
[ESC] %T
After the start command was sent, the following data is directly sent to the
optional device. Every data returned from the optional device is sent to the
host.
Transparentmode OFF
To end the transparentmode send the following data:
Command:
[ESC] EPS3_AUX_MODE_OFF
Watchdog starten
If 30 seconds no printer command is received, the printer reboots!
Command:
[ESC] %Z
Page 19 of 23
Version 1.3 - 19. April 2012