EasyPrinter S3 Programmers Manual
Set card collector mode
Set if card is dropped or stacked.
Command:
[ESC] %K [x]
[x] ... ASCII-character
'0' ... card is dropped
'1' ... card is stacked
Set card material mode
Preconfigures the print-/erase system for the selected TRW-material.
Command:
[ESC] %M [x]
[x] ... ASCII-character
'1' ... blue material Type 1 (Std)
'2' ... black material Type 1
Get card material mode
Get the actual selected TRW-material.
Command:
[ESC] %m
Returns:
One ASCII-character coding the TRW-material.
'1' ... blue material Type 1 (Std)
'2' ... black material Type 1
'3' ... black material Type 2
Set print area
Set the active print area.
Command:
[ESC] %d [yyyy] [YYYY]
[yyyy] ... ASCII-characters coding print area start in y-direction. (Valuerange:
000 - 1150 )
[YYYY] ... ASCII-characters coding print area end in y-direction. (Valuerange:
000 - 1150 )
Page 15 of 23
Version 1.3 - 19. April 2012