Get Chipreadertype; Get Printers Ip Address; Get Printers Subnetmask; Get Printerdefinitionbits - Ana-U EasyPrinter S3 Programmer's Manual

EasyPrinter S3 Programmers Manual

Get chipreadertype

Command:
[ESC] %oC
Returns:
One binary characters representing the printers internal chipreadertype
0xFF ... GIGATEK 125kHz reader
0x00 ... TWN3 Legic reader
0x01 ... StrongLink SL032

Get printers IP address

Command:
[ESC] %oI
Returns:
4 Byte defining the IP address of the printer.

Get printers Subnetmask

Command:
[ESC] %oN
Returns:
4 Byte defining the subnetmask of the printer.

Get PrinterDefinitionBits

Read the hardware definition.
Command:
[ESC] %oL
Returns:
One Byte with the actual setup.
Bit 0 ... Lightsensor back ( 0 = Top, 1 = Bottom )
Bit 1 ... Contactchip built-in
Bit 2 ... Uses static IP
Bit 3 ... Serial host interface directly connected to internal option
Bit 4 ... Kytronics CMT-2244C card collector to serial host interface connected
Bit 5 ... Terminalprinter
Bit 6 ... Cardedge detection using direction detection sensor
Bit 7 ... Do not use!
Page 17 of 23 Version 1.3 - 19. April 2012