Front Inner Panel And Drum - Electrolux EIGD55H Technical & Service Manual

R R o o l l l l e e r r A A s s s s e e m m b b l l y y R R e e m m o o v v a a l l
There are five roller assemblies that the dryer drum
rides upon. The roller shafts are secured to the
outside of the inner panels by a 9/16" nut. The
rollers slide onto the roller shafts and are secured
with triangular retainers.
To remove the roller assemblies:
1. Remove the top panel, rear panel, console,
front panel, front inner panel and drum.
N N O O T T E E : : With the drum removed, all roller
assemblies are accessible. Figure 4-32 illustrates
the front roller assemblies.
2. Using a 9/16" socket or wrench, remove the
nut from the roller shaft securing it to the inner
panel. A 3/8" wrench can be used on the
opposite end of the shaft to stop the shaft
from turning while loosening and tightening the
nut. (See Figure 4-31)
3. Pull roller assembly from inner panel.
4. Use a small flat bladed screwdriver and
remove the triangular retainer from the roller
shaft. Pull the roller from the roller shaft.
F F r r o o n n t t A A i i r r D D u u c c t t R R e e m m o o v v a a l l
The front air duct is secured with three screws to
the inner front panel. The two screws behind the
rollers are only accessible with the inner panel
removed from the unit.
To remove the front air duct:
1. Remove the top panel, rear panel, console,
front panel, front inner panel and drum.
2. From the backside of the front inner panel, use
a small flat bladed screwdriver and remove
the triangular retainer from the two roller
shafts. Pull the rollers from the roller shafts.
3. Using a #2 square bit screwdriver, extract
the three screws securing the front air duct to
the front inner panel. (See Figure 4-32)
C C o o m m p p o o n n e e n n t t T T e e a a r r d d o o w w n n
Inner
Panel
9/16"
Washers
Nut
F F i i g g u u r r e e 4 4 - - 3 3 1 1 . .
F F i i g g u u r r e e 4 4 - - 3 3 2 2 . .
4-13
Retainers
Roller
Screw
Rollers
Front Air Duct