Inner Door Glass - Electrolux EIGD55H Technical & Service Manual

C C o o m m p p o o n n e e n n t t T T e e a a r r d d o o w w n n
L L a a t t c c h h P P l l a a t t e e a a n n d d D D o o o o r r L L a a t t c c h h R R e e m m o o v v a a l l
The latch plate is secured with two long coarse
thread screws to the inner face of the door
assembly. The door latch is secured to the inside
of the latch plate with a screw and positioned on
locating pins. The door latch may be removed
without removing the door assembly.
To remove the latch plate:
1. Using a #2 square bit screwdriver, remove
the two long, course thread, countersunk
screws. (See Figure 4-4)
2. Lift latch plate from door assembly.
3. Using a #2 Phillips head screwdriver from the
underside of the latch plate, extract the screw
while compressing the spring assembly.
(See Figure 4-5)
4. Slowly release the spring assembly. Pivot the
door latch on the retaining pins so latch is 90
degrees to the latch plate. Slide door latch off
locating pins.
I I n n n n e e r r D D o o o o r r G G l l a a s s s s R R e e m m o o v v a a l l
The inner door glass is secured with screws that
pass through two retaining covers that are
mounted to the inner door assembly.
To remove the inner door glass:
1. Remove door assembly from unit.
2. Remove the latch plate.
3. Using a #2 square bit screwdriver, extract
the screws from the two retaining covers and
pull from door assembly. (See Figure 4-6)
4. Lift the inner door glass from door assembly
and remove the rubber gasket from door
glass.
F F i i g g u u r r e e 4 4 - - 4 4 . .
Locating
Pins
F F i i g g u u r r e e 4 4 - - 5 5 . .
F F i i g g u u r r e e 4 4 - - 6 6 . .
4-4
Latch Plate
Screws
Screw
Screws