Electrolux EIGD55H Technical & Service Manual page 28

I I n n s s t t a a l l l l a a t t i i o o n n I I n n f f o o r r m m a a t t i i o o n n
R R e e a a t t t t a a c c h h i i n n g g D D o o o o r r L L o o c c k k t t o o F F o o n n t t P P a a n n e e l l
1. Rotate the door lock and move it to the
opposite opening.
2. Connect the harness to the door lock by
inserting it in the terminal and firmly pushing
it in place. (See Figure 2-27)
3. Insert the harness connection through the
front panel first, and then pivot the lock until
it is flush. Slide the lock toward the center of
the front panel until the screw holes line up.
(See Figure 2-28)
4. Secure the lock with 2 short, course-thread,
panhead screws. (See Figure 2-29)
F F i i g g u u r r e e 2 2 - - 2 2 7 7 . .
F F i i g g u u r r e e 2 2 - - 2 2 8 8 . .
F F i i g g u u r r e e 2 2 - - 2 2 9 9 . .
R R e e a a t t t t a a c c h h i i n n g g H H i i n n g g e e t t o o F F r r o o n n t t P P a a n n e e l l
1. Rotate the hinge and move it to the opposite
opening.
2. Connect the harness to the hinge retainer
by inserting it in the retention terminal and
gently pushing until you hear the fastening
tab click. (See Figure 2-30)
3. Gently pull on the harness to be sure it is
secure.
4. Use the side locating pins to align the hinge
and install 1 short, fine-thread, counter-sunk
screw in the center hole of hinge side.
(See Figure 2-31)
5. Install the other 2 short, fine-thread, counter
sunk screws in upper and lower holes of hinge
side.
6. Install 2 short, course-thread, panhead
screws through hinge plate. (See Figure 2-32)
F F i i g g u u r r e e 2 2 - - 3 3 0 0 . .
F F i i g g u u r r e e 2 2 - - 3 3 1 1 . .
F F i i g g u u r r e e 2 2 - - 3 3 2 2 . .
2-18