Electrolux EIGD55H Technical & Service Manual page 26

I I n n s s t t a a l l l l a a t t i i o o n n I I n n f f o o r r m m a a t t i i o o n n
R R e e v v e e r r s s i i n n g g D D o o o o r r
P P r r e e p p a a r r i i n n g g t t o o R R e e v v e e r r s s e e D D o o o o r r S S w w i i n n g g
1. Be sure you have adequate swing area before
reversing door.
2. You will need a screw driver with a #2 square
bit.
3. Protect flat work surface, such as top of
washer or floor near washer, with a soft cloth
or towel.
4. Be sure washer is unplugged from power
source.
R R e e m m o o v v i i n n g g T T r r i i m m R R i i n n g g
1. Open the door to a 90 degree angle.
2. Remove and save the trim plug and long,
course-thread, panhead screw.
(See Figure 2-17)
3. Close the door.
4. Rotate the door trim approximately ¾"
counter-clockwise and pull it away from the
front of the door. (See Figure 2-18)
R R e e m m o o v v i i n n g g D D o o o o r r f f r r o o m m H H i i n n g g e e
1. Reopen door to 90 degree angle.
2. Remove 4 long, course-thread, counter-sunk
hinge screws from door. (See Figure 2-19)
3. While supporting the weight of the door with
both hands, separate the door from the hinge.
(See Figure 2-20)
4. Gently place the door face down on a flat,
covered work surface.
F F i i g g u u r r e e 2 2 - - 1 1 7 7 . .
F F i i g g u u r r e e 2 2 - - 1 1 8 8 . .
F F i i g g u u r r e e 2 2 - - 1 1 9 9 . .
F F i i g g u u r r e e 2 2 - - 2 2 0 0 . .
2-16