Electrolux EIGD55H Technical & Service Manual page 32

I I n n s s t t a a l l l l a a t t i i o o n n I I n n f f o o r r m m a a t t i i o o n n
R R e e v v e e r r s s i i n n g g T T r r i i m m R R i i n n g g
1. Trim ring orientation is marked on the back.
2. Remove the trim ring cover plate. To remove
the cover plate from the right, pivot point is
up. To remove the cover plate from the left,
pivot point is down. (See Figure 2-45)
F F i i g g u u r r e e 2 2 - - 4 4 5 5 . .
R R e e i i n n s s t t a a l l l l i i n n g g T T r r i i m m R R i i n n g g
1. Close the door.
2. Orient the trim so 12 position is approximately
¾" to the left of top center. The opening in the
trim ring should be on the hinge side.
3. Insert the trim ring in the slots and rotate it
clockwise approximately ¾". (See Figure 2-46)
F F i i g g u u r r e e 2 2 - - 4 4 6 6 . .
R R e e i i n n s s t t a a l l l l i i n n g g T T r r i i m m P P l l u u g g
1. Open the door to a 90 degree angle.
2. Install the trim plug with 1 long, course thread,
panhead screw. (See Figure 2-47)
3. Plug in washer and continue operation.
UP
2-22
F F i i g g u u r r e e 2 2 - - 4 4 7 7 . .