Leica Zeno 5 User Manual page 41

Zeno 5, Operation
Step Description
Only Zeno 5 can be charged in the docking station. Other PDAs with the
same battery terminating connector can NOT be charged.
1. Insert the DC plug from the power supply into the socket on the back of
the desktop charger.
2. Insert the country-compatible power coord into the power supply.
3. Plug the power cord into an external power supply.
4. Slide the Zeno 5 into the charger.
Press down to firmly seat the Zeno 5.
Do not place batteries in the docking stations if they are colder than 0°C
(32°F). Allow them to warm up to room temperature for at least 30 min.
5. The charge LED on the Zeno 5 (the left-most LED) lights up to indicate that
the unit has external power and may charge the internal battery. When the
Zeno 5 battery capacity reaches 95%, the LED turns solid green and
remains in this state once the battery is completely charged.
Refer to "3.5 LED Indicators on Docking Station" for information
about the charge LED.
6. Allow the battery to charge for at least 4 hours before use.
Full battery performance is only reached after the first few
charge/discharge cycles
41