Table of Contents
Advertisement
Using the product
5.3. Using the water fountain
(for certain models)
C
The first few glasses of water taken from
the fountain will normally be warm.
C
If the water fountain is not used for a long
time, dispose of the first few glasses of
water to get clean water.
You must wait approximately 12 hours to get cold
water after first operating.
Use the display to select the water option, then pull
the trigger to get water. Remove the glass shortly
after pulling the trigger.
5.4. Filling the fountain water tank
Open the water tank's lid, as shown in the figure.
Fill in pure and clean drinking water. Close the lid.
22 / 32 EN
Refrigerator / User Guide
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the SBS63XED and is the answer not in the manual?
Questions and answers
Where to connect water/ fill water on a dispenser
To connect water to the Smeg SBS63XED dispenser:
1. Connect the faucet adaptor to the cold water mains valve.
2. Fix the external water filter on the wall using the filter connecting apparatus.
3. Attach the filter upright on the apparatus, as indicated on the label.
4. Connect the water hose from the top of the filter to the product’s water connection adaptor.
5. Use hose clips to secure the hose and prevent movement.
6. Ensure all connections are tight and check for leaks after turning on the water.
Note: The water filter is not needed if using a carboy connection.
This answer is automatically generated
Water inlet
The water inlet specification for the Smeg SBS63XED is compatible with 3/4" and 1/2" BSP connectors, suitable for use with all mains water connections.
This answer is automatically generated