Table of Contents
Advertisement
MAINTENANcE
1
Remove 6 screws in locations shown below to access DFC.
6th screw located at back
2. Remove the DFC from the floor of the firebox by removing 2 screws in
locations shown below to release DFC bracket.
4. Disconnect the Black Pilot sensor wire with Red Spade connector from
the 'ON' on DFBC (Digital fireplace burner control) box.
See Diagram 1 below.
Pilot Sensor
Wire
32
DIGITAL FIREPLAcE BURNER cONTROL REMOvAL
Diagram 1
5. Disconnect the Black sparker wire with black spade connector from CN3.
See Diagram 2 below.
Sparker Wire
6. Disconnect the white and green On/Off switch wires.
See Diagram 3 below.
Green
7. Disconnect the yellow ground wire with green diagonal stripe for pilot
(CN2). See Diagram 4 below.
Ground wire
8. Disconnect the three valve wires (yellow wire with green stripe).
See Diagram 5 below.
Valve wire
Diagram 2
Diagram 3
ON/OFF wires
Diagram 4
Diagram 5
OD42 Outdoor Gas Fireplace
White
Advertisement
Table of Contents
