Table of Contents
Advertisement
installatiOn
Although this fireplace is designed to operate outdoors safely, rain and other sources of moisture may enter the hearth area, which will cause water to
collect inside the base of the unit.
to prevent excessive water collection, the installer must provide a way to drain the water from the base of the unit by building or installing a
water collector before positioning the fireplace in its location.
installatiOn instructiOns
When planning for the installation of the unit, the framing height must be increased by 3/4", when installing a drain pan. Additional space below the unit will
also be required to plumb a drain line.
1)
Remove 4 screws to remove the rear access panel from the back of the unit - this will allow access to the drain hole at the base of the unit.
2)
On the exposed drain hole (see location below), install a PVC 3/4" threaded coupling reducer going from the top of the pan, down through the hole.
Apply a silicone-based sealant around the base and threads before installation.
3)
Holding the reducer coupling with a wrench, thread a 90° PVC elbow (from the underside of the unit) to the reducer until it is tight to the metal.
note: To assure proper drainage, that fireplace must be installed on a leveled surface
4)
Add additional piping to route the drain to an appropriate location.
16
DRAIN INSTALLATION (REcOMMENDED)
Rear access panel
Drain hole
Threaded
Reducer
(PVC)
Reducer and elbow can be purchased from your local
hardware store.
Drain hole location at
base of the unit
OD42 Outdoor Gas Fireplace
Cut notches into the top
of the coupling reducer to
prevent water pooling.
Threaded
Elbow
@ 90°
(PVC)
Advertisement
Table of Contents
