Finishing - Outdoors Outdoor 42 Owners & Installation Manual

IMPORTANT FINIShING DETAIL NOTES FOR 2" AND 4" FAcEPLATES:
Before placing unit into final position - it is important to know the total thickness / height of finished hearth. The base of the fireplace should be
level or higher than the finished hearth height.
If material such as brick, stone, etc extends past the faceplate depth (1-1/2"), when finishing around the faceplate, the minimum opening dimensions
noted below must be adhered to ensuring for the removal of the faceplate and for the safe operation of this appliance.
2" Faceplate Finishing
For material such as brick, stone, etc that extend up to 1-1/2" , the minimum opening dimensions noted below must be adhered, when finishing around
the 2" or 4" faceplate. This is to ensure the removal of the faceplate and for the safe operation of this appliance.
Unit shown without faceplate
For facing/finishing material over 1-1/2" (38mm) thick, use the outer cut out for your
2" Faceplate cutout dimensions
OD42 Outdoor Gas Fireplace
41-1/2"
"
38-1/16"
"
faceplate template.
41-1/2"

FINIShING

installatiOn
4" Faceplate Finishing
4" Faceplate cutout dimensions
13