Table of Contents
Advertisement
3
PCB
Download Service Manual and Resetter Printer at http://printer1.blogspot.com
Does the print qualtty improve when
Clean the printer drum grounding
contact and cartridge contact, then
perform one test print. Does the print
About one second after the main
motor starts. does the voltage between
on the DC controller PCB change from
0 V to about 5 VDC'?
Check whether the hlgh-
voltage contact is making
good contact with the
primary charging roller of
the cartridge. If it is, replace
supply PCB. If the problem
persists after replacing the
PCB. check by using the
laser malfunction diagnosis
flowchart in Section 111 C.
NO
Replace the DC controller
PCB. If the problem persists
after replaclng the PCB,
check by using the laser
malfunction diagnosis
flowchart in Section III C.
6-17
Advertisement
Table of Contents
Troubleshooting
