Canon LBP-860 Service Manual page 131

Make sure the requirements below are met
when installing the printer. The service
engineer should inspect the place lhe
1. Power supply
Line vollage: No more than 2 10% outside
l
the rated voltage
Line frequency: SO/60 + 2 Hz
l
2. Operatinn conditions
Flat level. supporting surface
Ambient temperature of 10 lo 325°C
Humidity of 20 to 80% KH
No condensation
Good ventilation
Download Service Manual and Resetter Printer at http://printer1.blogspot.com
not install the printer in these places:
Do
.
the sun
If the printer must go somewhere sunny,
the windows must have curtains keep to
the sun off.
.
Near magnets or equipment that produces
a magnetic field
.
Where there is vibration
.
Where it is dusty
.
Near flames or water
There must be an enough space around the
printer to operate it. (See Figure 4-l) The
printer must go on a desk or other level
surface large enough to accommodate its
feet (and those
used) and sturdy
weight
Figure 4-l
CHAPTER 4
of the paper feeder, if
enough lo carry its