Securing Workpiece - Makita 2414NB Instruction Manual

1
2
3
4
003762
CAUTION:
Be sure to tighten the hex bolt securely. Insufficient
•
tightening of the hex bolt may result in severe injury.
Use the socket wrench provided to help assure
proper tightening.
Always use only the proper inner and outer flanges
•
which are provided with this tool.
Always lower the safety guard after replacing the
•
wheel.

Securing workpiece

1
003763
By turning the vise handle counterclockwise and then
flipping the vise nut to the left, the vise is released from
the shaft threads and can be moved rapidly in and out. To
grip workpieces, push the vise handle until the vise plate
contacts the workpiece. Flip the vise nut to the right and
then turn the vise handle clockwise to securely retain the
workpiece.
CAUTION:
Always set the vise nut to the right fully when
•
securing the workpiece. Failure to do so may result
in insufficient securing of the workpiece. This could
cause the workpiece to be ejected or cause a
dangerous breakage of the wheel.
When the cut-off wheel has worn down considerably, use
a spacer block of sturdy, non-flammable material behind
the workpiece as shown in the figure. You can more
efficiently utilize the worn wheel by using the mid point on
the periphery of the wheel to cut the workpiece.
1. O-ring
7
2. Inner flange
3. Ring
4. Spindle
5. Cut-off wheel
6. Outer flange
7. Hex bolt
6
5
1. Vise plate
2. Vise nut
2
3. Vise handle
3
003764
When cutting workpieces over 65 mm wide at an angle,
attach a straight piece of wood (spacer) over 190 mm
long x 45 mm wide to the guide plate as shown in the
figure. Attach this spacer with screws through the holes
in the guide plate.
1
2
5
3
4
005342
If you use a spacer block which is slightly narrower than
the workpiece as shown in the figure, you can also utilize
the wheel economically.
1
5
4
003766
Long workpieces must be supported by blocks of
non-flammable material on either side so that it will be
level with the base top.
003767
6
1. Spacer block
1
1. Guide plate
2. Straight piece of
wood (Spacer)
3. Over 45 mm
long
4. Over 65 mm
long
5. Over 190 mm
long
1. Diameter of
2
workpiece
2. Guide plate
3
3. Spacer block
4. Width of spacer
block
5. Vise
1. Blocks
1