Table of Contents
Advertisement
Receiving Headset Calls (Headset mode selected in option)
1. Press SPKR, and if necessary, press the green-flashing Call Appearance button.
2. Converse with the calling party.
3. When your conversation ends, hang up by pressing SPKR.
2
Note:
These procedures assume that the phone is set to ringing line preference or primary
line preference.
Switching between Handset and Handsfree Modes
1. Press SPKR and then replace the handset in its cradle. The other parties on the
call can now be heard through the speaker.
2. If the MIC-OFF LED is red, the microphone has been turned off. Press MIC-OFF to
turn it back on (the LED goes dark). The microphone now picks up your voice.
Note:
If the MIC-OFF feature is deactivated in the options the microphone is always on.
If handsfree mode is in use and want to use the handset, pick up the handset. The call
continues without interruption. The handsfree speaker and microphone are turned
off.
Last Number Redial
The Redial feature dials the last number that was dialed using the dial pad or a Speed
Dial key. Digits dialed will be saved in Outgoing Call Log.
Hold
Places caller on hold.
1. Press HOLD while active call is in progress. The Call Appearance LED changes
from steady red to rapidly flashing red.
2. To reconnect with a call on hold, press its flashing Call Appearance button. Its
LED changes from flashing red to steady red.
Note:
The Central office auto-hold feature automatically puts an active call on hold whenever
another Call Appearance is pressed.
Conference
This feature allows a telephone conference with multiple participants.
Note:
Conference is a network-based feature that is provided by your telephone company.
Conference size depends on your network configuration.
Conference by dialing the phone number
1. Press CONF while on an active call. The CONF button lights up. The initial call is
placed on hold, and the next available Call Appearance is selected.
2. Dial the party you want to add to the conference. Or press any Call Appearance
button that is ringing or on hold.
3. After the added party answers, press the CONF key to conference all parties
together.
4. Repeat the above steps to add another party. (If enabled for your phone)
2-2
Advertisement
Table of Contents
