Table of Contents
Advertisement
1. Press OPTIONS, numeric key "1", "0", then ENTER.
INTERCOM FEATURE
SUPPORTED (ALL)
2. Press ENTER.
1: ALL
3: NO SUPPORT
Select from the following:
1: ALL: all call appearances will be lit green and will be activated to
auto-answer.
2: SELECT: only selected Call Appearances with lit LEDs will auto-answer
on Call Announce.
3: NO SUPPORT: turns off LEDs green lights, none of the call appearances
on the recipient set will auto answer.
3. Press 1, 2, or 3 then ENTER. If 2 is selected, the following screen appears,
and LEDs will be lit:
SUPPORTED (SELECT)
SELECT ASSIGN KEY
4. Press the buttons to turn the LEDs on or off to select the desired Call
Appearance button(s). Buttons 1, 2, and 3 are quite often selected.
5. Press ENTER. The following screen is shown:
SUPPORTED (SELECT)
COMPLETED
Specifying the Directory Number for Intercom
To enable the Call Announce Intercom feature, specify a directory number of
the call screener(s) to be used to activate the intercom. Normal calls can still
be made from this Directory Number to numbers not set up for intercom. Up
to three-call screener Directory Numbers may be programmed. At the
conclusion of selecting buttons for Call Announce Intercom, this screen
appears:
SUPPORTED (SELECT/ALL)
COMPLETED
1. Press ENTER. If one or two way intercom is enabled, the screen displays
the enabled mode plus the authorized Directory Number, as shown
below:
TWO WAY TURNED ON
919*790*2222
2: SELECT
(SELECT 1-3)
(1)
3-17
3
Advertisement
Table of Contents
