Image Trouble - Toshiba e-studio 223 Operator's Manual For Copying Functions

Phenomenon
Copy paper jams.
Multiple feeding occurs.

Image trouble

Phenomenon
The density of the copy
image is light.
The density of the copy
image is dark.
The copied image is stained.
Usual cause
Copy paper not acceptable
for the equipment is being
used.
The size of the copy paper in
the drawer or on the bypass
tray is not registered prop-
erly in the equipment.
Jammed paper is located in
a place you cannot see eas-
ily.
There is no gap between the
side guides and paper in the
drawer. Or the gap is too
wide.
There is a gap between the
paper and the end guide in
the drawer.
Paper is clinging to each
other.
Usual cause
Toner has run out.
The copy density is set
lighter.
The transfer charger wire is
dirty.
The copy density is set
darker.
The Automatic Document
Feeder (optional) or the
Platen Cover (optional) is not
lowered fully.
The original glass, platen
sheet, scanning area or
guides are dirty.
The copy density is set
darker.
Highly transparent originals
such as OHP films or tracing
paper are used.
Before Calling Service Technician
Countermeasure
Check if the copy paper is acceptable for
the equipment.
P.35 "Paper types not acceptable"
Register the size of the placed copy paper
properly.
P.40 "Preparation 3 - Registering Size
of Paper Placed"
P.53 "Bypass copying"
Use the paper jam position lamp to
recheck the position where the paper jam
has occurred.
P.79 "Paper Jams"
Adjust the gap between the side guides
and the paper properly.
P.36 "Placing paper in drawers"
Do not allow any gap between the paper
and the end guide in the drawer.
P.36 "Placing paper in drawers"
Fan the paper well and place it again.
Countermeasure
The toner lamp blinks when toner has run
out. Replace the toner cartridge if it is
blinking.
P.90 "Replacing Toner Cartridge"
Make the density darker if you use the
manual copy density mode. Or use the
automatic copy density mode.
Clean the transfer charger wire.
P.102 "Cleaning transfer charger"
Make the density lighter if you use the
manual copy density mode. Or use the
automatic copy density mode.
Lower them fully to block outside light.
Clean them.
P.100 "Daily Inspection"
Make the density lighter if you use the
manual copy density mode. Or use the
automatic copy density mode.
Place a blank sheet of paper, the same
size as the original or larger, over the orig-
inal.
97