Table of Contents
Advertisement
GROUNDED
OUTLET
GROUNDING
PIN
((Canada, Mexico and United States)
Figure 1
Toma
corriente con
polo de
tierra
Terminal de
tierra
Figure 1a
Prise de
courant avec
mise à la
t e r r e
Broche de
mise à la
t e r r e
Figure 1b
Page - 12 -
Instructions for connection to the power
This product must be grounded. If the installation
should breakdown, grounding provides a path of low
resistance for electric current to reduce the risk of
electrical shock. This product is equipped with a cord
having an equipment-grounding conductor and ground-
ing plug. The plug must be inserted into an appropriate
oulet that is properly installed and grounded in accor-
GROUNDED
dance with all local codes and ordinances.
OUTLET BOX
This product is for use on a nominal 120 volt circuit and
has a grounding attachment plug that looks like the plug
illustrated in Figure 1. Make sure that the product is
connected to an outlet having the same configuration as
the plug. No adaptor should be used with this product.
Tampa del
toma
corriente con
polo de tierra
Boîte de
sortie mise
à la terre
EXTENSION CORDS
Use only an approved extension cord with three con-
ductors, a plug with three terminals, and a connector
body with three holes. The machine has a power cord
with wire size 14 AWG.
CLARKE TECHNOLOGY Operator's Manual - Ultra Speed Burnisher
120 VOLT MACHINES
supply and the electrical ground.
WARNING:
Improper connection of the
equipment-grounding conductor can re
sult in a risk of electric shock. Check with
a qualified electrician or service person if
you are in doubt as to whether the outlet is
properly grounded. Do not modify the
plug provided with the product. If it will
not fit the outlet, have a proper outlet
installed by a qualified electrician.
WARNING: To prevent possible electric
shock, protect the machine from rain.
Keep the machine in a dry building.
WARNING: To prevent possible electric
shock, always use a 3-wire electrical
system connected to the electrical ground.
For maximum protection against electri
cal shock, use a circuit that is protected by
a ground fault circuit interrupter. Consult
your electrical contractor.
WARNING: Do not cut, remove or break
the ground pin. If the plug does not fit
your outlet, consult your electrical
contractor.
WARNING: Have worn, cut or damaged
cords replaced by an authorized service
person.
WARNING: If you use an extension
cord, use an extension cord with
minimum wire size 12 AWG. Do not use
an extension cord longer than 50 feet.
Do not join two extension cords.
Advertisement
Table of Contents
