Advertisement
RETURN
ULTRA SPEED
Operator's
BURNISHER
Manual
1700
READ THIS BOOK
This book has important information for the use and safe operation of this machine. Failure to read
this book prior to operating or attempting any service or maintenance procedure to your ALTO
machine could result in injury to you or to other personnel; damage to the machine or to other property
could occur as well. You must have training in the operation of this machine before using it. If your
operator(s) cannot read English, have this manual explained fully before attempting to operate this
machine.
All directions given in this book are as seen from the operator's position at the rear of the machine.
For new books write to:
., 2100 Highway 265, Springdale, Arkansas 72764.
ALTO U.S. INC
Form No. 70127B
11/00
CLARKE TECHNOLOGY
Printed in the U.S.A.
Advertisement
Table of Contents
Related Manuals for Alto 1700
Summary of Contents for Alto 1700
- Page 1 This book has important information for the use and safe operation of this machine. Failure to read this book prior to operating or attempting any service or maintenance procedure to your ALTO machine could result in injury to you or to other personnel; damage to the machine or to other property could occur as well.
- Page 2 Buffer Wet-look hard finish 976236 UHS Aqua Burnish 1500-3000 Aqua Soft finish/low traffic Buffer Wet-look soft finish 976234 SHS Buffer Buff Dry/Spray 600-1500 Beige Glossy finish Spray Page - 4 - CLARKE TECHNOLOGY Operator's Manual - Ultra Speed Burnisher 1700...
- Page 3 ® Ultra Speed Burnisher 1700 Section II Parts and Service Manual (70127B) CLARKE TECHNOLOGY Operator's Manual - Ultra Speed Burnisher 1700 Page -11 -...
- Page 4 CLARKE TECHNOLOGY Ultra Speed Burnisher 1700 Assembly Parts List 11/00 Page - 14 - CLARKE TECHNOLOGY Operator's Manual - Ultra Speed Burnisher 1700...
- Page 5 Pad Driver (Includes 27, 31) 1 35703A Bumper 962714 Screw 170686 Locknut 57369A Retainer Pad (incl. w/25) 77378A Label, Clarke Technology (NOTE: Part Number 34259A requires retainer 80201A) CLARKE TECHNOLOGY Operator's Manual - Ultra Speed Burnisher 1700 Page -15 -...
- Page 6 CLARKE TECHNOLOGY Ultra Speed Burnisher 1700 Electrical Schematic 120Volts 11/00 Page - 16 - CLARKE TECHNOLOGY Operator's Manual - Ultra Speed Burnisher 1700...
- Page 7 Bearing - Lower 53528A Bottom End Plate 980076 Wave Washer 55646A Cord Assembly 59606A Varistor (120V) (w/8) 55647A Yellow Lead (w/8) 55648A Red Lead(w/8) 831102 Strain Relief 58056A Strain Relief CLARKE TECHNOLOGY Operator's Manual - Ultra Speed Burnisher 1700 Page -17 -...
Need help?
Do you have a question about the 1700 and is the answer not in the manual?
Questions and answers