Arctic Cat 2010 400 H1 TRV Operator's Manual page 72

Engine/Transmission
Oil and Filter
Change the engine oil and oil filter at
the scheduled intervals. The engine
should always be warm when the oil is
changed so the oil will drain easily and
completely.
1. Park the ATV on level ground.
2. Remove the oil level stick/filler
plug. Be careful not to allow con-
taminates to enter the opening.
3. Remove the drain plug from the
bottom of the engine and drain the
oil into a drain pan.
70
4. Using the oil filter wrench and a
ratchet handle (or a socket or box-
end wrench), remove the old oil
filter and dispose of properly. Do
not re-use oil filter.
 NOTE: Clean up any excess oil
after removing the filter.
5. Apply oil to the new filter seal and
check to make sure it is positioned
correctly; then install the new oil
filter. Tighten securely.
6. Install the engine drain plug and
tighten it securely. Pour the recom-
mended oil in the filler hole. Install
the level stick/filler plug.
7. Start the engine (while the ATV is
outside on level ground) and allow
it to idle for a few minutes.
8. Turn the engine off and wait
approximately
Recheck the oil level.
CF109A
9. Inspect the area around the drain
plug and oil filter for leaks.
Front Differential And
Rear Drive Gear
Lubricant (Inspecting/
Changing)
Check and change the gear lubricant in
each according to the Maintenance
GZ007C
Schedule. When changing the lubri-
cant, use approved SAE 80W-90 hyp-
oid oil and
procedure.
 NOTE: To check each, remove
each filler plug. The oil level
should be at the threads of each
plug.
1. Place the ATV on level ground.
2. Remove each oil filler plug.
3. Drain the oil into a drain pan by
removing in turn the drain plug
733-441A
from each.
three minutes.
use the following