CAUTION
Arctic Cat does not recommend
using a pressure washer to clean
the radiator core. The pressure may
bend or flatten the fins causing
restricted air flow, and electrical
components on the radiator could
be damaged. Use only a garden
hose with spray nozzle at normal tap
pressure.
3. Mode Button - Shifts the gauge
through three set-up modes: speed-
ometer/tachometer, distance, and
time.
NOTE: The Mode Button must be
pressed and released to shift
modes. Approximately two sec-
onds after the Mode Button is
released, the digital gauge will
return to full display.
4. Set/Reset Button - In conjunction
with the Mode Button, sets and
resets various displays on the digi-
tal gauge. Also used to shift from
speedometer function to tachome-
ter function on the speedometer/
tachometer gauge.
5. Fuel Level Indicator - Indicates
approximate amount of gasoline in
the gas tank.
NOTE: When the bottom seg-
ment flashes, approximately 3.5 L
(0.92 U.S. gal.) of gasoline remains
in the tank.
6. Low Oil Pressure - Will be dis-
played during self-test at start-up.
It will not be displayed during nor-
mal operation as oil pressure is not
monitored on these models.
7. Odometer/Trip Meter - Odometer
registers the total distance the
vehicle has traveled. The trip
meter is resetable and can be used
to measure trip or trip legs. The
odometer cannot be reset.
56
NOTE: To shift between the
odometer (ODO) or trip meter
(TRIP), press the Mode Button (3)
to select the distance mode; then
press the Set/Reset Button (4) to
select the desired display. Hold the
Set/Reset Button down to reset the
trip meter.
8. Gear Position Indicator - Indicates
which gear is selected.
• R
(reverse)/N
(neutral)/L
range)/H (high range).
NOTE: An E will be displayed if
there is an error caused by a no-
shift position signal.
9. High Beam Indicator - The High
Beam icon will appear only when
the headlights are on high beam.
10. 4WD Lock Indicator - Displays
LOCK when the front differential
lock has been engaged.
11. Drive Select Indicator - Displays
4WD when selected by the drive
select switch or when the 4WD
lock is engaged. The display is
blank when in 2WD.
12. Speedometer
-
approximate vehicle speed in
miles per hour (MPH) or kilome-
ters per hour (km/h).
NOTE: To change mph/km/h dis-
play, press and release Mode But-
ton (3) until the icon (MPH/km/h)
appears; then press the Set Button
(4) to change the display.
Condition Warning Display - Uses
odometer/trip meter display of the
LCD to warn of a system error condi-
tion requiring attention.
(low
Indicates
the