Panasonic KX-UTG300 Operating Instructions Manual page 53

Network
Setting
IP Address Mode
IPv4
IPv6
Document Version 2014-11
Sub-Setting
— Specify the IP address mode
to use.
Enable DHCP Enable or disable DHCP for
IPv4.
IP Address If DHCP is not enabled, you
must specify the IP address.
Subnet Mask If DHCP is not enabled, you
must specify the subnet
mask.
Default Gateway If DHCP is not enabled, you
must specify the default
gateway.
Auto DNS Enable or disable Auto DNS
for IPv4.
DNS1 If Auto DNS is not enabled,
you can specify the primary
DNS server IP address.
DNS2 If Auto DNS is not enabled,
you can specify the
secondary DNS server IP
address. Leave blank if a
secondary DNS server is not
used.
Enable IPv6 Enable or disable DHCP for
DHCP IPv6.
Allow Auto Enable or disable auto
Configuration configuration for IPv6.
Enable IPv6 Enable or disable privacy for
Privacy IPv6.
IPv6 Address If DHCP is not enabled, you
must specify the IP address.
IPv6 Prefix If DHCP is not enabled, you
Length must specify the prefix length.
IPv6 Default If DHCP is not enabled, you
Gateway must specify the default
gateway.
IPv6 Auto DNS Enable or disable Auto DNS
for IPv6.
IPv6 DNS1 If IPv6 Auto DNS is not
enabled, you can specify the
primary DNS server IP
address.
Description
Customizing the Telephone
Value Range Default
IPv4 only
IPv6 only
Dual stack
Yes, No
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
Yes, No
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
Yes, No
Yes, No
Yes, No
1-46 characters
1-128
1-46 characters
Yes, No
1-46 characters
Operating Instructions
Dual
stack
Yes
—
—
—
Yes
—
—
Yes
Yes
No
—
—
—
Yes
—
53