Glass Replacement; Control Board Replacement; Fuse Replacement; Feed Motor Replacement - Pelpro PP60 Owner's Manual

F. Glass Replacement
1. Open the door from the appliance by lifting door off of hinge
pins and lay on a fl at surface face down.
2. Using a Phillips Head screw driver, remove the 3 brackets
and set aside.
3. Remove old glass and replace with the new glass.
4. Re-install the brackets using the same screws.
WARNING
• Glass is 5mm thick high temperature heat-
resistant ceramic glass.
• DO NOT REPLACE with any other material.
• Alternate material may shatter and cause
injury.
G. Control Board Replacement
1. Turn the dial control to the off position. Unplug the power
to the unit.
2. Unplug the wires from the control board. The connectors
are locking connectors. Pinch the release tab on each
connector and gently tug and rock loose.
3. Pinch the 4 plastic pins from the rear of the unit to release
the control board connectors.
4. Install new board following the steps in reverse.
H. Fuse Replacement
1. Turn the dial control to the off position. Unplug the power
to the unit.
2. Pull the plastic fuse holder cover off the control board.
3. Replace fuse with 5AMP 120VAC fuse only.
4. Replace the cover on the fuse holder and restart unit.
20
I. Feed Motor Replacement
1. Turn the dial control to the off position and unplug the unit.
Remove the right side panel and feed motor cover plate
in the rear of the unit.
2. Unplug the connector from the feed motor.
3. Using pliers, remove the cotter pin.
4. Remove the feed motor from the feed shaft.
5.
Reinstall the new feed motor by aligning the clearance hole in the
feed motor shaft with the auger spring shaft and re-install the cotter
pin.
6. Plug the feed motor leads back in and restore power.
J. Feed Spring Replacement
1. Empty the hopper of all pellets. then follow the steps to
remove the feed motor above.
2. Remove the four screws holding the feed motor bracket
on.
3. Slide the auger assembly out from the bottom in the rear
of the unit.
4. Inspect the bronze bearings, replace if needed.
5. Install new spring assembly following reverse steps
including reattaching the feed motor.
7083-171H • February 23, 2015 www.pelprostoves.com