FAAC 400 Installation Manual
Swing gate system
Hide thumbs
Also See for 400:
- Instruction manual (32 pages) ,
- User manual (30 pages) ,
- Installation manual (24 pages)
Related Manuals for FAAC 400
Summary of Contents for FAAC 400
- Page 1 Installation Manual Swing Gate System Leading the way ... Leading the way ... Leading the way ...
-
Page 2: Table Of Contents
Symbol draws your attention to the notes about the product’s characteristics or operation. FAAC S.p.A. Via Benini, 1 40069 Zola Predosa (BO) - ITALIA Tel.: 051/61724 - Fax: 051/758518... -
Page 3: Ec Declaration Of Conformity For Machines
17) FAAC declines all liability as concerns safety and efficient operation source of danger. of the automated system, if system components not produced by 6) FAAC declines all liability caused by improper use or use other than that FAAC are used. for which the automated system was intended. -
Page 4: Description And Technical Specifications
AUTOMATED SYSTEM 400 These instructions apply to the following models: 400 CBC - 400 CBAC - 400 SB - 400 SBS - 400 CBACR - 1.1. DIMENSIONS 400 CBAC long - 400 SB long. The FAAC 400 automated system for swing leaf gates consists of Fig. -
Page 5: Installing The Automated System
3. INSTALLING THE AUTOMATED SYSTEM 3.2.1 GENERAL RULES FOR DETERMINING THE INSTALLATION DIMENSIONS 3.1. PRELIMINARY CHECKS If the dimensions indicated in table A or B cannot be executed, the following must be considered in order to determine different To ensure a correctly operating automated system, the structure measurements: of the existing gate or gate to be built must satisfy the following to obtain 90°... - Page 6 Secure the operator to the rear attachment with the Fig. 8 supplied screws (Fig. 6). Screw, halfway down, the front attachment onto the rod (ref. Fig.8) and tighten with the supplied nut. Release the operator (see chapter 7). Fully remove the rod to its stop point and make it recede by about 5 mm (Fig.7).
-
Page 7: Start-Up
- Fasten the screws (Fig. 14A). 4.1. ADJUSTING THE ANTI-CRUSHING SYSTEM The 400 automated system has an anti-crushing safety device which limits the operator's force if an obstacle is encountered while the gate is moving. To adjust the intervention threshold of the anti-crushing system, temporarily open the release unit. -
Page 8: Automated System Test
6. AUTOMATED SYSTEM TEST When you have finished installing, apply the danger signal sticker on the side of the operator so that it is clearly visible (Fig.15). Run an accurate functional check of the automated system and of all the accessories connected to it, especially the safety devices. -
Page 9: Maintenance
The safety devices installed on the system must be checked every 6 months. 11. REPAIRS For any repairs, contact FAAC’s authorised Repair Centres. 12. TROUBLESHOOTING The following table will help you identify and solve some particular conditions. I T I . - Page 11 These instructions apply to the following models: N.B.: IN MODELS WITHOUT THE LOCKS, ALL YOU HAVE TO DO IS TO 400 CBC - 400 SB - 400 SBS - 400 CBAC - 400 CBACR - MANUALLY RELEASE THE ELECTRIC LOCK.
- Page 12 The descriptions and illustrations contained in this manual are not The descriptions and illustrations contained in this manual are not binding. FAAC reserve the right, whilst leaving the main features of binding. FAAC reserve the right, whilst leaving the main features of binding.
Need help?
Do you have a question about the 400 and is the answer not in the manual?
Questions and answers