Pppoe (Username/Password) - D-Link DIR-860L User Manual

Section 3 - Configuration
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide you with a username and password.
This option is typically used for DSL services. Make sure to remove any PPPoE software from your computer. The software is not needed and will
not work through a router.
My Internet Select PPPoE.(Username/Password) from the drop-down menu.
Connection:
Enable Advanced Domain Name System (DNS) enhances your Internet
Advanced DNS
performance by getting you the information and web pages you are
Service: looking for faster and more reliably. In addition, it improves your overall
Internet experience by correcting many common typing mistakes
automatically, taking you where you intended to go and saving you
valuable time.
Disclaimer: D-Link makes no guarantee as to the availability, reliability,
functionality and operation of the Advanced DNS service or its features.
Enable True
Check to enable true Gigabit routing. This will increase the throughput
Gigabit Routing of the WAN-LAN connectivity of the router.
Connectivity:
Address Mode: Select Static.IP if your ISP assigned you an IP address, subnet mask,
gateway, and DNS server addresses. In most cases, select Dynamic.
IP Address: Enter the IP address (Static PPPoE only).
Username: Enter your PPPoE username.
Password: Enter your PPPoE password and then retype the password in the next box.
Service Name: Enter the ISP Service Name (optional).
Reconnect Select either Always-on, On-Demand, or Manual.
Mode:
D-Link DIR-860L User Manual

PPPoE (Username/Password)

28