Pppoe (Username/Password) - D-Link DIR-815 User Manual

Section 3 - Configuration
Select PPPoE (Username/Password) from the drop-down menu if your ISP uses a PPPoE connection. Your ISP will provide you
with a username and password. This option is typically used for DSL services. Make sure to remove your PPPoE software from
your computer. The software is no longer needed and will not work through a router.
Address Mode:
Select Static IP if your ISP assigned you the IP address,
subnet mask, gateway, and DNS server addresses. In most
cases, select Dynamic.
IP Address:
Enter the IP address (Static PPPoE only).
User Name:
Enter your PPPoE user name.
Password:
Enter your PPPoE password and then retype the password
in the next box.
Service Name:
Enter the ISP Service Name (optional).
Reconnect Use the radio buttons to specify the reconnect mode.
Mode:
The user can specify a custom schedule or specify the On
Demand, or Manual option.
To specify a custom schedule, use the drop-down menu to
select one of the schedules that has been defined in the
Tools> Schedules window. To create a new schedule, click
the New Schedule button to open the Tools> Schedules
window. Refer to "Schedules" on page 83 for more information.
Maximum Idle
Enter a maximum idle time during which the Internet
Time:
connection is maintained during inactivity. To disable this
feature, enable Auto-reconnect.
DNS Servers:
Enter the Primary and Secondary DNS Server Addresses (Static PPPoE only).
D-Link DIR-815 User Manual
Manual Internet Connection Setup

PPPoE (Username/Password)

31