D-Link DIR-860L User Manual page 57

Section 3 - Configuration
Static.IPv6.Address.Connection
This mode is used when your ISP provides you with a set of IPv6 addresses that does not change. The IPv6 information is manually entered in your
IPv6 configuration settings. You must enter the IPv6 address, Subnet Prefix Length, Default Gateway, Primary DNS Server, and Secondary DNS
Server. Your ISP provides you with all of this information.
The Link-local address is used by nodes and routers when
Use Link-Local
communicating with neighboring nodes on the same link. This mode
Address:
enables IPv6-capable devices to communicate with each other on
the LAN side.
Enter the WAN IPv6 address for the router here.
IPv6 Address:
Enter the WAN subnet prefix length value used here.
Subnet Prefix
Length:
Enter the WAN default gateway IPv6 address used here.
Default Gateway:
Enter the WAN primary DNS Server address used here.
Primary DNS
Address:
Enter the WAN secondary DNS Server address used here.
Secondary DNS
Address:
These are the settings of the LAN (Local Area Network) IPv6 interface for the router. The router's LAN IPv6 Address configuration is
LAN IPv6 Address:
based on the IPv6 Address and Subnet assigned by your ISP. (A subnet with prefix /64 is supported in LAN.)
D-Link DIR-860L User Manual 53