Pppoe (Username/Password) - D-Link DIR-602 User Manual

Section 3 – Configuration
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide
you with a username and password. This option is typically used for DSL services. Make sure to remove your PPPoE
software from your computer. The software is no longer needed and will not work through a router.
PPPoE Enter your PPPoE user name.
UserName:
PPPoE Enter your PPPoE password and then
Password: retype the password in the next box.
PPPoE Service Enter the ISP Service Name (optional).
Name:
Idle Time: Enter a maximum idle time during which
the Internet connection is maintained
during inactivity. To disable this feature,
enable Auto-reconnect.
MTU: Maximum Transmission Unit - you may
need to change the MTU for optimal
performance with your specific ISP. 1492 is
the default MTU.
MAC Address: The default MAC Address is set to the
Internet port's physical interface MAC
address on the Broadband Router. It is not
recommended that you change the default
MAC address unless required by your ISP.
You can use the Clone MAC Address
button to replace the Internet port's MAC
address with the MAC address of your
Ethernet card.
D-Link DIR-602 User Manual

PPPoE (username/password)

24