Initial Parameter Setup (Users Set Up) - Skyrc e6680 Instruction Manual

INITIAL PARAMETER SETUP (USERS SET UP)

INITIAL PARAMETER SETUP (USERS SET UP)
As default this charger will be set to typical user settings when it is
connected to AC 110-240V or DC 11-18V for the first time. The
screen displays the following information in sequence and the user
can change the parameter on each screen.
If you need to alter the parameter value in the program, press
"Start/Enter" key to make it blink then change the value with "INC"
or "DEC" key. The value will be stored by pressing "Start/Enter" key
once.
USER SET
PROGRAM->
INC
LiFe
V.Type 3.3V
- +
DEC INC
DEC INC
LiPo/LiIo/LiFe
CHK Time 10min
User setup starting screen.
The screen displays the nominal voltage of
Lithium battery. There are three kinds of Lithium
battery: LiFe(3.3V), Lilon(3.6V) or LiPo(3.7V).
This is very important so you have to check the
battery carefully and set it up correctly. If it is
different from correct value the battery may be
exploded during charge process.
e6680 recognize the cell count of Lithium battery
automatically at the beginning of charge or
discharge process to avoid from erroneous
setting by user. But deeply discharged battery
can be perceived incorrectly. To prevent the
error, you can set the time term to verify the cell
count by the processor. Normally, 10 minutes
are enough to perceive the cell count correctly.
For the battery of larger capacity, you may
extend the time term. But if you set the time
term to long for the battery of smaller capacity,
the charge or discharge process can be finished
within the time term with the erroneous cell count.
This may cause the fatal result. If the processor
- 12 -