Parts Names - Sanyo VCC-3700P Instruction Manual

PARTS NAMES

(VCC-3700P)
1
2
3
(VCC-3770P)
1
2
3
4
1
3
7
8
2
3 2
1
1
1
Shorter screws: M3 x 4
2
Longer screws: M3 x 6
3
Camera mounting screw
hole: 1/4"-20 UNC
English
1
Power indicator (POWER)
Comes on when the power to the camera is on.
2
Video output connector (VIDEO OUT: BNC type)
5
Connect this connector to a device such as a VCR or monitor
with a VIDEO IN connector.
4
3
AC power cord
4
External sync composite video signal input connector
(VBS IN: BNC type)
Connect to this connector the synchronizing signal output
5
from a synchronizing signal device or the composite signal of
a video distributor.
5
Line phase adjustment screw (LINE PHASE)
When using two cameras or more, the image on the
6
monitor may roll vertically when switching sources. This
rolling can be minimized by turning this screw.
2
6
Y/C OUT connector (4 pin)
4
Separate Y (luminance) and C (chroma) signals are output
from this terminal.
A better picture quality is obtained if the monitor or VCR is
connected to this connector.
1 Y signal ground
3 Y signal: 1.0 Vp-p, 75 ohms, unbalanced, negative sync
4 C signal: 0.3 Vp-p, 75 ohms, unbalanced
7
Lens mount cap
The cap is installed to protect the lens mount section.
Remove the lens mount cap before installing a lens (sold
separately).
8
Camera installation bracket
The bracket can be fixed at the top or bottom of the
camera. When fixing the bracket, be sure to use the longer
screws and install the shorter screws on the opposite side to
seal the openings.
CAUTION:
When installing the camera support, select a location
that can support the total weight of the camera and
accessories.
3
2 C signal ground