Using The Clock And Timer; Power Outage - GE Coil Top Owner's Manual And Installation Instructions

Using the clock and timer.

Not all features are on all models.
Clock
Start
On
Make sure the clock is set to the
correct time of day.
Timer
Start
On
The timer is a minute timer only.
The Off pad does not affect
the timer.
Timer
OR
Cook
Time
To Set the Clock
The clock must be set to the correct time of day
for the automatic oven timing functions to work
properly. The time of day cannot be changed
during a delayed cooking or a delayed self-
cleaning cycle.
Touch the Clock pad twice.
Touch the + or – pads.
If the + or – pads are not touched within one
minute after you touch the Clock pad, the
To Set the Timer
The timer does not control oven operations.
The maximum setting on the timer is 9 hours
and 59 minutes.
Touch the Timer pad.
Touch the + or – pads until the amount of
time you want shows in the display. The
maximum time that can be entered in
minutes is 59. Times more than 59 minutes
should be changed to hours and minutes.
If you make a mistake, touch the Timer pad and
begin again.
To Reset the Timer
If the display is still showing the time remaining,
you may change it by touching the Timer pad,
then touching the + or – pads until the time you
want appears in the display.
To Cancel the Timer
Touch the Timer pad twice.
End of Cycle Tones
(on some models)
Clear the tones by pressing the pad of the
function you are using.

Power Outage

If a flashing time is in the display, you have
experienced a power failure. Reset the clock.
display reverts to the original setting. If this
happens, touch the Clock pad twice and
reenter the time of day.
Touch the Start/On pad until the time of
day shows in the display. This enters the
time and starts the clock.
To check the time of day when the display is
showing other information, simply touch the
Clock pad. The time of day shows until another
pad is touched.
Touch the Start/On pad. The time will start
counting down, although the display does
not change until one minute has passed.
When the timer reaches :00, the control
will beep 3 times followed by one beep
every 6 seconds until the Timer pad is
touched.
If the remaining time is not in the display (clock,
delay start or cooking time are in the display),
recall the remaining time by touching the Timer
pad and then touching the + or – pads to enter
the new time you want.
To reset the clock, touch the CLOCK pad twice.
Enter the correct time of day by touching the +
or - pads. Touch the START/ON pad.
GEAppliances.com
13