GE Coil Top Owner's Manual And Installation Instructions page 39

Problem
Oven temperature too
hot or too cold
Clock and timer do
not work
Display goes blank
Oven door is crooked
Oven makes clicking
noise
"F-and a number or
letter" flash in the
display
Power outage
Display flashes
Unable to get the
display to show "SF"
"Burning" or "oily
odor emitting from
the oven vent
Strong odor
Possible Causes
Oven thermostat needs
adjustment.
Plug on rang is not completely
inserted in the electrical outlet.
A fuse in your home may be
blown or the circuit breaker
tripped.
Oven controls improperly set.
A fuse in your home may be
blown or the circuit breaker
tripped.
The clock is turned off from
showing in the display.
The door is out of position.
This is the sound of the heating
element turning off and on during
the cooking functions.
You have a function error code.
If the function code repeats:
Power outage or surge
Power failure
Oven control pads were not
pressed properly
This is normal in a new oven and
will disappear in time.
An odor from the insulation
around the inside of the oven is
normal for the first few times the
oven is used.
What To Do
• See the Adjust the oven thermostat - Easy to do yourself!
section.
• Make sure electrical plug is plugged into a live, properly
grounded outlet.
• Replace fuse or reset circuit breaker.
• See the Using the clock, timer, and convenience outlet
section.
• Replace the fuse or reset the circuit breaker.
• See the Using the clock, timer, and convenience outlet
section.
• Because the oven door is removable, it sometimes gets
out of position during installation. To straighten the door,
push down on the high corner.
• This is normal.
• Press the OFF pad. Put the oven back into operation
• Disconnect all power to the range for at least 30 seconds
and then reconnect power. If the function error code
repeats, call for service
• On self-cleaning models, if a function error code appears
during the self-cleaning cycle, check the oven door latch.
• Press the OFF pad. Allow the oven to cool for one hour.
Put the oven back into operation.
• Some models will automatically resume their setting
once the power is restored. On models with a clock, you
must reset the clock. If the oven was in use, you must
reset it by pressing the OFF pad, setting the clock and
resetting any cooking function.
• Reset the clock.
• The BAKE and BROIL pads must be pressed at the same
time and held for 3 seconds.
• To speed the process, set a self-cleaning cycle for a
minimum of 3 hours. See the Using the self-cleaning oven
section.
• This is temporary.
GEAppliances.com
39