How To Self-Check And Hdd Format - FUNAI TD6D-M101 Service Manual

HOW TO SELF-CHECK AND HDD FORMAT

1. Turn on the HDD & DVD/VCR.
2. To put the HDD & DVD/VCR into the HDD mode, press [HDD] on the remote control unit.
3. To put the HDD & DVD/VCR into the self-check mode, after pressing [VARIABLE SKIP] button, press the [0],
[7], and [9] buttons on the remote control in that order within three seconds.
Fig. a appears on the screen.
Table 1: Description of Fig. a
INDICATION
DVD CONNECT STATUS (*1)
HDD CONNECT STATUS (*2)
HDD POWER ON HOURS (*3)
4. Upon the self-check completion, Fig. b appears on the screen.
SELF CHECK
*1
DVD CONNECT STATUS :
*2
HDD CONNECT STATUS :
*3
HDD POWER ON HOURS :
HDD FORMAT START :
POWER OFF :
Fig. a Self-Check Mode Screen
Connecting Condition of DVD(F/E)
Connecting Condition of HDD
Value of HDD power on hours obtained from S.M.A.R.T. command. (If not obtainable,
value of HDD power on hours is "0".)
Value in parentheses is the factory setting value. (If no setting, the value is "0".)
SELF CHECK
*4
DVD CONNECT STATUS :
*5
HDD CONNECT STATUS :
HDD POWER ON HOURS :
*6
HDD FORMAT START :
*7
POWER OFF :
Fig. b Screen of Finishing Self-Check Mode
ENTER
POWER
DESCRIPTION
OK
OK
70
ENTER
POWER
1-9-1 E3TF0HSC