FUNAI TD6D-M101 Service Manual page 14

Note:
(1): Identification (location) No. of parts in the figures
(2): Name of the part
(3): Figure Number for reference
(4): Identification of parts to be removed, unhooked,
unlocked, released, unplugged, unclamped, or
desoldered.
P=Spring, L=Locking Tab, S=Screw,
CN=Connector
e.g. 6(S-1) = six Screws of (S-1),
5(L-1) = five Locking Tabs of (L-1)
(5): Refer to "Reference Notes."
Reference Notes
1. Locking Tabs (L-1) and (L-2) are fragile. Be careful
not to break them.
1-1. Remove Screw (S-2).
1-2. Release four Locking Tabs (L-1).
1-3. Release three Locking Tabs (L-2).
1-4. Disconnect Connector (CN6001), and
remove the Front Assembly.
2. The DVD Mechanism & DVD/HDD Main CBA
Assembly is adjusted as a unit at factory.
Therefore, do not disassemble it. Replace the
DVD Mechanism & DVD/HDD Main CBA
Assembly as a unit.
3. Whenever you have replaced the HDD unit, format
the HDD unit. To format the HDD unit, perform the
following.
3-1. To put the HDD & DVD/VCR into the HDD
mode, press the [HDD] button on the remote
control unit.
3-2. To put the HDD & DVD/VCR into the self-
check mode, after pressing [VARIABLE
SKIP] button, press the [0], [7], and [9]
buttons on the remote control in that order
within three seconds.
3-3. Press [ENTER/OK] button. The HDD & DVD/
VCR is formatted and the power is turned off
automatically after two seconds.
4. When reassembling, solder wire jumpers as
shown in Fig. D8.
5. Before installing the Deck Assembly, be sure to
place the pin of LD-SW on the AV CBA as shown
in Fig. D8. Then, install the Deck Assembly while
aligning the hole of Cam Gear with the pin of LD-
SW, the shaft of Cam Gear with the hole of LD-SW
as shown in Fig. D8.
[1] Top Cover
(S-1)
(S-4)
(S-4)
Front
Support
(S-4)
(L-1)
(S-2)
(L-2)
1-7-2
(S-1)
(S-1)
(S-1)
Fig. D1
[4] Front Bracket
(S-5)
(S-3)
CN6001
(L-1)
[3] USB
CBA
USB Holder
USB Earth Plate
[2] Front Assembly
Fig. D2
E3TFGDC