Once The Fireplace Is Complete - Jøtul S 43 C Installation And Operating Instructions Manual

ENGLISH
6.0 Once the fireplace is
complete
See installation and user instructions for the Jøtul I 350 FL
(cat. no. 129543) for use and maintenance of the fireplace.
Minor imperfections
After the fireplace has been installed you should smooth over
any minor imperfections or unevenness in the concrete using
the included cement filler.
• In order to achieve the best result the surround should
be rubbed down with fine sandpaper, smoothing any
unevenness or sharp edges prior to painting.
• Apply one coat of paint.
• Mix the powder (cement filler) with water to form a smooth
paste (with the same consistency as toothpaste).
• Smooth any unevenness, allow to dry and rub down with fine
sandpaper.
• If the imperfections are deep we recommend that you apply
the filler in applications in order to prevent the filler from
sinking.
• Paint once more with the desired colour.
7.0 Mounting optional
equipment
Glass front plate - fig. 5 and 6
1. Attach the glass plate with the screws provided. See fig. 6.
2. Measure precisely the position of the holes on the surround
and mark where they are to be drilled.
3. Drill one 3 mm hole and attach the sleeve (part A) with the
screw. Screw the screw directly into the surround. Hang the
glass and attach with washers and nuts (part B). Check the
position of the other marks and attach the glass in the same
way at the other holes.
Glass top plate - fig. 7
Place the sleeves on the grate inside the concrete edge.
Place the glass plate on top.
Glass floor plate
Place the floor plate loosely up to the front of the surround.
12