Lanier 5222 Operator's Manual page 75

The following procedure describes the printer port settings.
Windows 95/98
Windows NT 4.0
Windows 3.1x
Macintosh
Troubleshooting
Possible Cause
Is the Data In indicator
blinking or lit after
starting the print job,
when using the PCL
printer?
1. Click [Start], point to [Settings], and then click [Printers].
2. Click the icon of the printer. Next, on the [File] menu, click [Properties].
3. Click the [Details] tab.
4. Check the [Print to the following port:] list to confirm the correct port is
selected.
1. Click [Start], point to [Settings], and then click [Printers].
2. Click the icon of the printer. Next, on the [File] menu, click [Properties].
3. Click the [Port] tab.
4. Confirm that the correct port is selected.
1. On [Control Panel], double-click the [Printers] icon.
2. Confirm that this printer is specified as the default printer.
3. Click [Connect].
4. Check the [Ports] list to confirm the correct port is selected.
1. Click [Apple Menu], point to [Control Panels], and then select [Apple Talk].
2. Confirm that [Ethernet] is selected in the [connect via:] list.
Solutions
If not, the data is not being sent to the printer, or the
printer may be resetting the print job because there was a
long delay in receiving the data from the computer.
If the printer is using "I/O Timeout"
Increase the value of the "I/O Timeout" setting of the
"System" menu of the "Job Control". See "Making Printer
Settings with the Operation Panel" on page 7-5
If your machine is connected to the computer using the
parallel cable
Confirm that the printer port settings are correct. For a
parallel port connection, port LPT1 or LPT2 should be set.
For more information on the printer port settings, see the
Note after this table.
Network Connection
Contact your network administrator.
Printer Does Not Print
6 - 13