Lanier 5222 Operator's Manual page 66

Error and Status Messages
6 - 4
Messages Description
Remove Paper The standard output tray is full. Remove paper from the output
Standard Tray
Remove Paper The PT270 (1bin tray) is full.
1Bin Tray
Reset Duplex The AD370 (duplex unit) is not
Unit Correctly set correctly.
Resetting Job... Resetting Print job.
Reset Tray XX There is no paper tray, or Tray
Correctly XX is not set correctly.
This message appears only for
the default tray. See "Job
Control Parameters" on page 7-
7.
Setting Changed The paper feed unit setting has
Cannot Print been changed, and the proof
print failed.
Waiting... Printer is waiting for the next
data to print.
Warming Up... The printer is now preparing for
printing.
Note: If you cannot solve the problem by taking above actions, turn the main
power switch off and then back on again. If this does not clear the error message,
write down the error message, and contact your sales or service representative.
Comments
tray.
Remove the paper from output
tray before it becomes full. If
you leave paper in the output
tray, it can cause a paper
misfeed.
Remove the paper from the
PT270 (1bin tray).
Remove the paper from the
output tray before it becomes
full. If you leave paper in the
tray, it can cause a paper
misfeed.
Set the AD370 (duplex unit)
correctly.
Wait for while.
Set the tray correctly.
Configure the paper feed unit
correctly, and try again.
Wait for a while.
Wait until the printer is warmed
up.
Troubleshooting