Makita HR3000C Instruction Manual page 7

CAUTION:
*Do not rotate the change lever and/or the shift lever when the tool is running under
load. The tool will be damaged.
*To avoid rapid wear on the mode change mechanism, be sure that the change lever
and/or the shift lever is always positively located in one of the three action mode posi-
tions.
*The action mode cannot be changed
directly from "hammering only" to
"rotation only" or from "rotation only"
to "hammering only". First set the
change lever and the shift lever to "rota-
tion with hammering" mode position
shown in right. Then set them to the
position for "hammering only" or "rota-
tion only".
Hammering only Rotation only
I
Rotation with hammering
Bit angle [when chipping, scaling or demolishing)
CAUTION:
Always be sure that the tool is switched off and unplugged before changing the bit angle.
The bit can be secured
a t 12
different
angles. To change the bit angle, depress
the lock button and rotate the change lever
so that the pointer points to the 0 symbol.
Turn the bit to the desired angle.
Lock
7
Depress the lock button and rotate the
change
lever so
that the pointer points to
the symbol. Then make sure that the bit
is securely held in place by turning it slight-
ly.
7