Makita HR3000C Instruction Manual page 10

ASS EM B LY
Installing or removing bit
CAUTIO
N :
Always be sure that the tool is switched off and unplugged before installing or removing
the bit.
Clean the bit shank and apply the bit grease
provided to it before installing the bit.
Insert the bit into the tool. Turn the bit and
push it in until it engages.
If the bit cannot be pushed in, remove the
bit. Pull the chuck cover down a couple of
times. Then insert the bit again. Turn the
bit and push it in until it engages.
After installing, always make sure that the
bit is securely held in place by trying to pull
it out. To remove the bit, pull the chuck
cover down
all
the way and pull the bit out.
10