Download Print this page

Makita HR3000C Instruction Manual page 16

30 mm (1-3/16”
Hide thumbs Also See for HR3000C:

Advertisement

Rest the tool on the table with the bit end pointing upwards. This will allow the old grease
to collect inside the crank housing. Wipe out the old grease inside and replace with
a
fresh
grease (30 g). Use only Makita genuine hammer grease (optional accessory). Filling with
more than specified amount of grease (approx. 30 g) can cause faulty hammering action
or tool failure. Fill only with the specified amount of grease. Reinstall the crank cap and
tighten with the hex wrench.
Connect the connector and reinstall the handle.
Connector
White
%
Black
CAUTION:
Be careful not to damage the terminal or lead wires especially when wiping out the old
Do not tighten the crank cap excessively. It is made of resin and is subject to breakage.
grease or installing the handle.
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjust-
ment should be performed by Makita Authorized or Factory Service Centers, always using
Makita replacement parts.
16

Advertisement

loading